£0 
This site is best viewed in Google Chrome, Firefox or Safari. Click here to remove this message.
Magura Valve bolt - part G
Use this part G to fix through part F (the 90º pipe connector) and connect into the brake caliper.. This special screw is hollow with a hole and allows the blood to flow through the system.. Ensure you have copper washers (part H) either side of the Part F to ensure a water tight fit.. Make sure this part is screwed into the caliper tight, but do not over tighten as it is fragile & will snap!.. We are checking the Magura website for details of its exact tightness in newton meters...
Weight: 5g
HCC: 8714949019
Related Products
-
Magura Bolt mounting Spacer MG Stainless Steel - Part B - -
Brake disk support spacer - fits between the spoke and the disk M4 x10 x 10mm - -
MAGURA P - Lever Handle & Grip - -
Magura Bolt used to mount the calipers to the hanger - PartC - -
Magura Bolt used to mount the calipers to the hanger - part D - -
Magura Cable connector Wide - part J - -
Magura MT7 HC3 Red - Special Edition - -
Magura connecting copper Washer - part H - -
BRAKE DISKS - 5mm CNC Aluminum SOLID or VENTED to fit 5 spoke TRAMPA Hubs - -
Magura brake cable - 2 Meter service Length - -
Magura Brake Calipers & Cables - -
Magura brake cable - 265mm repair length between calipers - -
Magura Banjo Cable connector Narrow - part K - -
Magura Brake service kit - -
Magura Bleed Bung in Caliper - part I - -
Brake Disk Bolt M4x 62.5mm - Fits PHATLADS hub to Brake Disk Purchased as M4x 70mm cut down to 63cm by hand - -
M4 x 52.5mm countersunk bolt - Marine Grade Stainless steel Brake disk to hub bolt - -
Magura 90º Bango cable connector - part F -
+44 (0)115 8410006
All images and material on this site not covered by other copyright and not explicitly marked as public domain is © Trampa Boards 2000 - 2024