M6 12x12mm Nikle plated Flush fitting Threaded Insert Nut Used for neatly securing the Monster Box to the Deck

This M6 12m x 12mm RAMPA Muffen or Insert nut will allow you to secure M6 Bolts to your deck without the need of using often unsightly or protruding nut on the other side leaving a neat clean smooth finish to your assembly....

We use the M6 RAMPA Nuts to secure the MONSTER BOX to the center of the Electric Mountainboard Deck & butt is also possible to secure your Bindings to the deck in the same way.

To make the hole to accept the fitting the nut, you will need to measure accurately so first make a pilot hole using a 2/3mm drill bit. Then specifically using a 10,5mm Steel drill bit, carefully drill the larger sized hole remembering to drill at 90º to the surface. If you do not Drill 90º to the surface your RAMPA Nuts will not fit flush...

Once you have made the 10.5mm holes, use a 6mm Allen Key to screw the RAMPA nut into the deck. Be careful when screwing in, you need to add a little bit of force to make it bite into the surrounding material, but not too much force as you do not wish to push through anything.... Turning the M6 Allen Key may be tough as when screwing the nut into the deck as it will literally cutting a thread into the surrounding material of the deck as you do...  It may help secure the RAMPA nuts even better if you add a tiny squirt of Glue as you tighten up the last few turns...